NETTOYEUR/TRAY ULTRASONS PROFESSIONAL ANALOGIQUE 30L 600 WATTS WITH VALVE OF DRAIN (500X300X200MM) -SPECIAL RAMPE OF CARBURETTOR- (PREMIUM QUALITY)

Ultrasonic cleaning of all types of car-motorcycle-boat-aeronautical carburettors, ultrasonic degreasing and deoxidation of mechanical parts in maintenance workshops, deburring of 3D printing deposits, cleaning of socket cases before reloading, cleaning diving equipment, cleaning and disinfecting dental or veterinary instruments, laboratory equipment, deoxidizing electronic circuits (mobile phone repair), etc...

Ultrasonic power: 850 watts peak/600 W RMS
Ultrasonic frequency: 40 kHz
Drain valve: yes
Heating: Yes
Heating power: 800 Watts (fast heating)
Adjustable temperature from 0 to 80°
Mechanical timer 0 to 20 min, automatic shut-off
Stainless steel basket + lid

Directions for use:

A manual in French is provided with the device, we invite you to read it before use.
Here are some tips for use to ensure an optimal cleaning experience:
1.Install the 6L cleaner on a flat, stable surface.
2.Add the tap water and then the ultrasonic cleaning solution. suitable for your parts and approved for ultrasonic use.
3.Ne not fill the tank beyond the recommended limit. This will cause spills and damage the unit. As a reminder, this ultrasonic tank must be used with a water level of at least 3/4 of the total capacity of the tank and maximum 1/4 of the room volume. Refer to the demarcation at the top of the tank.
4.Connect the cleaner to the mains and turn the switch on.
5.Degassing your bath by ultrasound for 5-10 minutes.
6.Place the item in the shopping cart. Avoid overloading the basket: this can reduce cleaning efficiency and damage the appliance.
7.Set the temperature and duration of the cleaning cycle, then turn on.
8.To end the cleaning process, press the corresponding keys again. If no buttons have been touched, the ultrasonic process will not stop until the timer reaches 00:00.
9.Rinse the parts with clean water after passing through an ultrasonic bath to remove any deposits on them.
10.Drain, clean and dry your ultrasonic tank after use before storage.